Quick way to install pillars


Save time and effort in the installation of wooden poles is quite possible if you resort to this simple and simple technique. So, immediately to the point, what is the trick. The usual, classical method implies digging a well, installing a timber and pouring an empty cavity with a ready-made concrete solution. Speaking of two words of course.
What does the quick install method mean? The fact is that the preparation of concrete takes a lot of time and effort. I propose to omit these steps and prepare the composition directly in the well for the installation. See what happens next is not worse.

Will need


  • Cement-sand mixture. All is calculated individually. Usually goes from 1 to 3 bags per pillar. On average, a bag - 25 kg, sold in any hardware store.

Install the wooden pole in a fast way


At the beginning, everything is as usual: we dig a ditch about 1 meter deep. At the bottom we place a stone or brick, set and align all the pillars in height.
Quick way to install pillars

Timber from all sides, for sustainability, we are laying stones or fragments of bricks.
Quick way to install pillars

Align all the level in all planes.
Quick way to install pillars

And here is the use of a non-standard method: we take a watering hose with tap water and very abundantly water the voids in the well.
Quick way to install pillars

Open the bag with the cement-sand mixture and evenly scatter it from all sides of the pillar.
Quick way to install pillars

Before backfilling, I strongly recommend using a respirator or dust mask for builders. It is good to wear goggles to prevent the mixture from getting into your eyes.
At these steps, you can fix the pillar, if he went to the side.







Related news

Quick way to install pillars image, picture
Quick way to install pillars 52


Quick way to install pillars 52


Quick way to install pillars 68


Quick way to install pillars 40


Quick way to install pillars 19